CANISTER(w/o Canister Pump Module) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCHARGE FUEL SYSTEM PRESSURE

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

5. REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

6. REMOVE FRONT DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

7. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

8. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

10. REMOVE REAR FLOOR SERVICE HOLE COVER

    Click here

11. REMOVE CANISTER (FUEL TANK VENT TUBE ASSEMBLY)

    Click here

12. REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY

    Click here