NAVIGATION SYSTEM Disc cannot be Ejected

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly may not operate normally.

PROCEDURE


  1. CHECK OPERATION


    1. Press the disc eject switch of the radio receiver assembly for 5 seconds or more and check that the disc is ejected.

      OK
      Disc is ejected.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    OK

  2. REPLACE DISC AND RECHECK


    1. Replace the disc with a new or known good one and check that the malfunction disappears.

      OK
      Disc is ejected.
      Result
      Proceed to
      OK
      NG

    OK

    END (DISC WAS FAULTY)

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here