FUEL PRESSURE PULSATION DAMPER INSTALLATION

PROCEDURE


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.

    2. B0074OLC02
      *1 Gasket
      *2 Fuel Pressure Pulsation Damper Assembly
      *3 Fuel Tube Sub-assembly

      Install 2 new gaskets, the fuel tube sub-assembly and fuel pressure pulsation damper assembly to the fuel pump assembly.

    3. B0077YBC01
      *a Torque Wrench Fulcrum Length

      Using SST, tighten the fuel pressure pulsation damper assembly to the fuel pump assembly.

      SST
      09612-24014   ( 09617-24011 )
      Torque:
      Specified tightening torque
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 52 mm (2.05 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 31 N*m (316 kgf*cm, 23 ft.*lbf)

  2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  3. CONNECT NO. 2 VENTILATION HOSE

    Click here

  4. INSTALL ENGINE ROOM SIDE COVER

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSPECT FOR FUEL LEAK

    Click here

  7. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here