REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

      Note


      • Using height adjustment attachments and plate lift attachments, keep the engine assembly level.

      • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before servicing.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

    3. B0077Z5C01
      *a Oil Seal Protrusion Height

      Using SST and a hammer, tap in the rear engine oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil Seal Protrusion Height
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note

      Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B00743NN04

      Using SST, hold the crankshaft pulley.

      SST
      09213-70010   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. B0076M9C03
      *1 Crank Angle Sensor Plate
      *2 Drive Plate and Ring Gear Sub-assembly
      *3 Rear drive plate Spacer
      B0073AQ Automatic Transmission Side

      Install the crank angle sensor plate, drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Tech Tips

      As the crank angle sensor plate, drive plate and ring gear sub-assembly and rear drive plate spacer are not reversible, be sure to install them in the direction shown in the illustration.

    4. B0075REC02
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    5. B0074WAE01

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. INSPECT FOR ENGINE OIL LEAK

    Click here