REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

      Note


      • Using height adjustment attachments and plate lift attachments, keep the engine assembly level.

      • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before servicing.

    2. B00743NC03

      Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    3. B0074WA

      Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and crank angle sensor plate.

  3. REMOVE REAR ENGINE OIL SEAL


    1. B0074X4C03
      *a Cut Position
      *b Protective Tape

      Using a knife, cut through the rear engine oil seal.

    2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.

      Note

      Be careful not to damage the crankshaft.