FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new timing chain case oil seal.

      Note

      Keep the lip free of foreign matter.

    2. B00779QC02
      *a Oil Seal Protrusion Height

      Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.

      SST
      09223-22010
      09506-35010
      Oil Seal Protrusion Height
      0 to 1.0 mm (0 to 0.0394 in.)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. Install the crankshaft timing gear key to the key groove.

  3. INSTALL CRANKSHAFT PULLEY


    1. B0074RLC02
      *a Hold
      B0073AQ Turn

      Align the pulley set key with the key groove of the crankshaft pulley.

    2. Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

  4. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY

    Click here

  5. INSTALL NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

    Click here

  6. INSTALL V-RIBBED BELT

    Click here

  7. INSTALL FAN SHROUD

    Click here

  8. ADD ENGINE OIL

    Click here

  9. INSPECT ENGINE OIL LEVEL

    Click here

  10. INSPECT FOR ENGINE OIL LEAK

    Click here