REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Clean the crankshaft and rear engine oil seal retainer.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal section.

    3. B0075NZC03
      *a Standard Depth

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.

      SST
      09223-15030   ( 09951-07150 )
      Standard Depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

      • Do not tap in the rear engine oil seal more than necessary.

      • Do not deform the rear engine oil seal.

      • Wipe off excess MP grease from the crankshaft.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B0076D0N01

      Using SST, hold the crankshaft pulley.

      SST
      09330-00021   ( 09213-70020 )

    2. Clean the 8 bolts and 8 bolt holes.

    3. B0073X7C04
      *a Pin Hole
      *b Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. B007643C01
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B0073AQ Transmission Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Tech Tips

      As the drive plate and ring gear sub-assembly and the rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. B0075DTC90
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note

      Install the bolt within 3 minutes of applying adhesive.

    6. B0075UCN02

      Install and uniformly tighten the 8 bolts in several steps, in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSPECT DRIVE PLATE

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  5. INSPECT FOR ENGINE OIL LEAK

    Click here