ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *A | w/ No.2 Engine Under Cover | - | - |
| *1 | INLET NO. 1 AIR CLEANER | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY | *4 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| *5 | NO. 1 ENGINE COVER SUB-ASSEMBLY | *6 | NO.1 ENGINE UNDER COVER ASSEMBLY |
| *7 | NO. 2 ENGINE UNDER COVER | *8 | FRONT SUSPENSION MEMBER BRACE |
| *9 | REAR ENGINE UNDER COVER LH | *10 | REAR ENGINE UNDER COVER RH |
| *11 | NO. 1 VENTILATION HOSE | *12 | COOL AIR INTAKE DUCT SEAL |
| *13 | AIR CLEANER ASSEMBLY WITH NO. 2 AIR CLEANER HOSE | *14 | ENGINE ROOM SIDE COVER |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | ENGINE ROOM ECU COVER | *2 | V-RIBBED BELT |
| *3 | FUEL TUBE SUB-ASSEMBLY | *4 | INLET HEATER WATER HOSE A |
| *5 | INTERCOOLER RESERVE TANK ASSEMBLY | *6 | NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
| *7 | SUCTION HOSE | *8 | NO. 1 FUEL VAPOR FEED HOSE |
| *9 | NO. 3 INTERCOOLER COOLING WATER HOSE | *10 | NO. 2 RADIATOR HOSE SUB-ASSEMBLY |
| *11 | NO. 1 ENGINE ROOM RELAY BLOCK COVER | *12 | OUTLET HEATER WATER HOSE A |
| *13 | RADIATOR HOSE SUB-ASSEMBLY | *14 | UNION TO CHECK VALVE HOSE |
| *15 | WATER HOSE SET | *16 | NO. 4 INTERCOOLER COOLING WATER HOSE |
| *17 | O-RING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
for HFC-134a (R134a): Compressor oil ND-OIL 8 or equivalent for HFO-1234yf (R1234yf): Compressor oil ND-OIL 12 or equivalent |
- | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | ENGINE ROOM ECU COVER | *2 | V-RIBBED BELT |
| *3 | FUEL TUBE SUB-ASSEMBLY | *4 | INLET HEATER WATER HOSE A |
| *5 | INTERCOOLER RESERVE TANK ASSEMBLY | *6 | NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
| *7 | SUCTION HOSE | *8 | NO. 1 FUEL VAPOR FEED HOSE |
| *9 | NO. 3 INTERCOOLER COOLING WATER HOSE ASSEMBLY | *10 | NO. 2 RADIATOR HOSE SUB-ASSEMBLY |
| *11 | NO. 1 ENGINE ROOM RELAY BLOCK COVER | *12 | OUTLET HEATER WATER HOSE A |
| *13 | RADIATOR HOSE SUB-ASSEMBLY | *14 | UNION TO CHECK VALVE HOSE |
| *15 | WATER HOSE SET | *16 | NO. 1 INTERCOOLER COOLING WATER HOSE |
| *17 | O-RING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
for HFC-134a (R134a): Compressor oil ND-OIL 8 or equivalent for HFO-1234yf (R1234yf): Compressor oil ND-OIL 12 or equivalent |
- | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | ENGINE WIRE | *2 | NO. 2 ENGINE WIRE |
| *3 | NO. 3 ENGINE WIRE | *4 | NO. 4 ENGINE WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | ENGINE WIRE | *2 | NO. 2 ENGINE WIRE |
| *3 | NO. 3 ENGINE WIRE | *4 | NO. 4 ENGINE WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | ENGINE ASSEMBLY WITH TRANSMISSION | *2 | FRONT CENTER FLOOR BRACE SUB-ASSEMBLY |
| *3 | FRONT LOWER BALL JOINT ASSEMBLY LH | *4 | FRONT LOWER SUSPENSION ARM ASSEMBLY |
| *5 | FRONT LOWER SUSPENSION MEMBER PROTECTOR | *6 | FRONT SHOCK ABSORBER ASSEMBLY LH |
| *7 | FRONT UPPER NO. 2 SUSPENSION MEMBER | *8 | NO. 3 ENGINE WIRE |
| *9 | STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY | *10 | SUSPENSION TOWER DAMPER |
| *11 | STRUT BAR BRACKET REINFORCEMENT LH | *12 | STRUT BAR BRACKET REINFORCEMENT RH |
| *13 | FRONT NO. 2 STABILIZER BRACKET LH | *14 | FRONT NO. 2 STABILIZER BRACKET RH |
| *15 | FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY | *16 | SHIFT LEVER |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | ENGINE ASSEMBLY WITH TRANSMISSION | *2 | FRONT CENTER FLOOR BRACE SUB-ASSEMBLY |
| *3 | FRONT LOWER BALL JOINT ASSEMBLY LH | *4 | FRONT LOWER SUSPENSION ARM ASSEMBLY |
| *5 | FRONT LOWER SUSPENSION MEMBER PROTECTOR | *6 | FRONT SHOCK ABSORBER ASSEMBLY LH |
| *7 | FRONT UPPER NO. 2 SUSPENSION MEMBER | *8 | NO. 3 ENGINE WIRE |
| *9 | STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY | *10 | SUSPENSION TOWER DAMPER |
| *11 | STRUT BAR BRACKET REINFORCEMENT LH | *12 | STRUT BAR BRACKET REINFORCEMENT RH |
| *13 | FRONT NO. 2 STABILIZER BRACKET LH | *14 | FRONT NO. 2 STABILIZER BRACKET RH |
| *15 | FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY | *16 | SHIFT LEVER |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/ Stop And Start System | *B | w/o Stop And Start System |
| *1 | AUTOMATIC TRANSMISSION ASSEMBLY | *2 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
| *3 | EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front and Rear Catalyst) | *4 | FLYWHEEL SIDE COVER |
| *5 | NO. 1 EXHAUST MANIFOLD HEAT INSULATOR | *6 | NO. 13 WATER BY-PASS HOSE |
| *7 | NO. 4 EXHAUST MANIFOLD HEAT INSULATOR | *8 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
| *9 | REAR ENGINE MOUNTING MEMBER | *10 | REAR NO. 1 ENGINE MOUNTING INSULATOR |
| *11 | STARTER ASSEMBLY | *12 | WATER BY-PASS HOSE |
| *13 | NO. 2 EARTH WIRE | *14 | NO. 2 WATER BY-PASS HOSE |
| *15 | TURBOCHARGER STAY | *16 | WIRE HARNESS |
| *17 | HEATER WATER PUMP ASSEMBLY | *18 | OUTLET TURBINE ELBOW GASKET |
| *19 | REAR DRIVE PLATE SPACER | *20 | FRONT DRIVE PLATE SPACER |
| *21 | EXHAUST PIPE CLAMP | - | - |
| *a | Black: x 1 Silver: x 5 |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Clutch spline grease |  |
Adhesive 1324 |
| ★ | Precoated part | - | - |
ILLUSTRATION
| *1 | AIR TUBE | *2 | REAR END PLATE |
| *3 | FRONT ENGINE MOUNTING INSULATOR | *4 | NO. 3 VENTILATION HOSE |
| *5 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *6 | NO. 1 AIR HOSE |
| *7 | NO. 2 AIR HOSE | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |