REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A01R5COC02
      *a Standard Depth

      Using SST, evenly tap in the rear engine oil seal until its surface is flush with the edge of the cylinder block sub-assembly.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard Depth
      -0.45 to 0.45 mm (-0.0177 to 0.0177 in.)

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01R4CWN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the 8 bolts and bolt holes.

    3. A01R6FAC02
      *a Pin Hole
      *b Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01R4IUC02
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      *a Automatic Transmission Side

      Install the drive plate and ring gear sub-assembly and the rear drive plate spacer to the crankshaft.

      Note

      The rear drive plate spacer and the drive plate and ring gear sub-assembly are not reversible. Be sure to install them as shown in the illustration.

    5. B0075DTC89
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01R43XN02

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here