DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT


    1. B0073YOC01
      *1 Water Pump Assembly
      *2 Generator Assembly
      *3 No. 2 Idler Pulley Sub-assembly
      *4 V-ribbed Belt Tensioner Assembly
      *5 Crankshaft Pulley
      *6 Compressor and Magnetic Clutch Assembly

      Set the V-ribbed belt onto every pulley.

      Note


      • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.

      • Check that the V-ribbed belt is properly set to each pulley.

    2. While turning the V-ribbed belt tensioner assembly counterclockwise, remove the 5 mm bi-hexagon wrench.

    3. B0077RWC14
      *a Correct
      *b Incorrect

      Check that the V-ribbed belt fits properly in the ribbed grooves.

      Tech Tips

      Check by hand to confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.