THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE ENGINE ROOM SIDE COVER

    Click here

  4. REMOVE INTAKE AIR SOUND CREATOR (w/ INTAKE AIR SOUND CREATOR)

    Tech Tips

    Only perform this procedure when replacement of the intake air sound creator is necessary.


    1. B0073CC

      Loosen the hose clamp.

    2. Remove the bolt and intake air sound creator from the air cleaner cap with air cleaner hose.

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B00751MC01
      *A w/ Intake Air Sound Creator
      *B w/o Intake Air Sound Creator

      Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

    2. B007686

      Disconnect the mass air flow meter sub-assembly connector.

    3. Disconnect the wire harness clamp from the air cleaner cap with air cleaner hose.

    4. B0076LL

      Disengage the clamp to disconnect the fuel vapor feed hose from the air cleaner cap with air cleaner hose.

    5. B0076AXC01
      *A w/ Intake Air Sound Creator
      *B w/o Intake Air Sound Creator

      Release the 4 clamps.

    6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  6. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B0076K3

      Slide the clip and disconnect the No. 16 water by-pass hose from the throttle body with motor assembly.

    2. B007738

      Disconnect the throttle body with motor assembly connector.

    3. Remove the 4 bolts and separate the throttle body with motor assembly from the intake air surge tank assembly.

    4. B00757I

      Slide the clip and disconnect the water by-pass hose to remove the throttle body with motor assembly.

  7. REMOVE THROTTLE BODY GASKET


    1. B0074JN

      Remove the throttle body gasket from the intake air surge tank assembly.