HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing a heated oxygen sensor. (w/ Canister Pump Module)

    Click here


    1. for Bank 2:


      1. B0076SDC01
        *a Torque Wrench Fulcrum Length

        Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

        SST
        09224-00010
        Torque:
        Specified tightening torque
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }

        Note

        If the heated oxygen sensor has been struck or dropped, replace it.

        Tech Tips


        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Click here

        • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

          39 N*m (398 kgf*cm, 29 ft.*lbf)

      2. Connect the heated oxygen sensor grommet to the vehicle body.

    2. for Bank 1:


      1. B00766XC01
        *a Torque Wrench Fulcrum Length

        Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

        SST
        09224-00010
        Torque:
        Specified tightening torque
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }

        Note

        If the heated oxygen sensor has been struck or dropped, replace it.

        Tech Tips


        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Click here

        • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

          39 N*m (398 kgf*cm, 29 ft.*lbf)

      2. Connect the heated oxygen sensor grommet to the vehicle body.

  2. CONNECT HEATED OXYGEN SENSOR CONNECTOR


    1. for Bank 2:


      1. Engage the clamp.

      2. Connect the heated oxygen sensor connector.

      3. Install the floor carpet to the original position.

    2. for Bank 1:


      1. Engage the clamp.

      2. Connect the heated oxygen sensor connector.

      3. Install the floor carpet to the original position.

  3. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here

  5. PERFORM INITIALIZATION (w/ Canister Pump Module)


    1. Perform "Inspection After Repair" after replacing a heated oxygen sensor.

      Click here