AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing an air fuel ratio sensor. (w/ Canister Pump Module)

    Click here


    1. for Bank 2:


      1. B0076LZC01
        *a Torque Wrench Fulcrum Length

        Using SST, install the air fuel ratio sensor to the exhaust manifold LH.

        SST
        09224-00010
        Torque:
        Specified tightening torque
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }

        Note

        If the air fuel ratio sensor has been struck or dropped, replace it.

        Tech Tips


        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Click here

        • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

          39 N*m (398 kgf*cm, 29 ft.*lbf)

      2. Connect the air fuel ratio sensor connector.

    2. for Bank 1:


      1. B0075NPC01
        *a Torque Wrench Fulcrum Length

        Using SST, install the air fuel ratio sensor to the exhaust manifold RH.

        SST
        09224-00010
        Torque:
        Specified tightening torque
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }

        Note

        If the air fuel ratio sensor has been struck or dropped, replace it.

        Tech Tips


        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Click here

        • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

          39 N*m (398 kgf*cm, 29 ft.*lbf)

      2. Engage the 2 wire harness clamps.

      3. Connect the air fuel ratio sensor connector.

  2. INSTALL BATTERY TRAY (for LHD)


    1. Install the battery tray with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Engage the fuel pipe clamp to the battery tray.

  3. INSTALL BATTERY TRAY (for RHD)


    1. Install the battery tray with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. INSTALL POWER STEERING ECU ASSEMBLY


  5. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  6. INSPECT FOR EXHAUST GAS LEAK

    Click here

  7. PERFORM INITIALIZATION (w/ Canister Pump Module)


    1. Perform "Inspection After Repair" after replacing an air fuel ratio sensor.

      Click here