KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK CONTROL SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing a knock control sensor. (w/ Canister Pump Module)

    Click here


    1. B00765EC02
      *A for Bank 1
      *B for Bank 2
      *a View A
      *b View B
      *c Top
      *d Engine Front
      *e Engine Rear
      B0073AQ Front
      B0077IM View A
      B0077LI View B

      Install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • Make sure that each knock control sensor is in the correct position.

      • If a knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

    2. Connect the 2 knock control sensor connectors.

  2. INSTALL FUEL INJECTOR ASSEMBLY

    Click here

  3. PERFORM INITIALIZATION (w/ Canister Pump Module)


    1. Perform "Inspection After Repair" after replacing a knock control sensor.

      Click here