ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

   Tech Tips

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor. (w/ Canister Pump Module)

   Click here

   
   

   1. Install a new gasket to the engine coolant temperature sensor.

   2. 

      *a	19 mm Ball Joint Lock Nut Wrench
      *b	Torque Wrench Fulcrum Length

      Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor to the rear water by-pass joint.

      Torque:

      Specified tightening torque

      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 19 mm ball joint lock nut wrench (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 155 mm (6.1 in.)):

        10 N*m (102 kgf*cm, 7 ft.*lbf)

   3. Connect the engine coolant temperature sensor connector.

2. CONNECT WATER BY-PASS HOSE

   
   

   1. Connect the water by-pass hose to the rear water by-pass joint and slide the clip to secure it.

3. INSTALL FUEL PRESSURE SENSOR

   Click here

4. PERFORM INITIALIZATION (w/ Canister Pump Module)

   
   

   1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Click here