KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the knock sensor.



    1. A01R50FC01
      *a Up
      *b Front of Engine
      *c 10°

      Install the knock sensor to the cylinder block sub-assembly with the bolt so that the knock sensor installation position is as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • If the knock sensor has been struck or dropped, replace it.

      • Make sure that the knock sensor is installed in the correct position.

    2. Connect the knock sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here

  3. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the knock sensor.