CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring.

      Note

      If reusing the crankshaft position sensor, check the O-ring.

    2. B0075DTC95
      *a Adhesive

      Apply adhesive to 2 or 3 threads of a new bolt.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    3. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.

      • If the crankshaft position sensor has been struck or dropped, replace it.

    4. Connect the crankshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here

  3. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here