CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      Note

      When reusing a camshaft position sensor, check the O-ring.

    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

      • If a camshaft position sensor has been struck or dropped, replace it.

    3. Connect the camshaft position sensor connector.

    4. Connect the fuel pump assembly connector.

  2. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      Note

      If reusing a camshaft position sensor, check the O-ring.

    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

      • If a camshaft position sensor has been struck or dropped, replace it.

    3. Connect the camshaft position sensor connector.

  3. INSPECT FOR ENGINE OIL LEAK

    Click here

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here