ECM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.

      w/ Canister Pump Module:

      Click here

      w/o Canister Pump Module:

      Click here

    • If the ECM has been struck or dropped, replace it.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE ENGINE ROOM ECU COVER

    Note


    • Remove all water on and around the engine room ECU cover.

    • Perform the inspection indoors to avoid rain.

    • Be sure to prevent water intrusion to the ECM (connectors and screw parts).


    1. B0076OB

      Remove the 3 bolts and engine room ECU cover.

  4. REMOVE ECM


    1. B0075H7C01
      *a Push
      *b Lock

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. B00749J

      Remove the 2 nuts and ECM from the engine room ECU box.

      Note

      If the ECM has been struck or dropped, replace it.

  5. REMOVE NO. 1 ECM BRACKET


    1. B0075LY

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  6. REMOVE NO. 2 ECM BRACKET


    1. B0077ID

      Remove the 2 screws and No. 2 ECM bracket from the ECM.