AUDIO AND VISUAL SYSTEM(for 7 Inch Display) PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

      System Name See Procedure
      Lane Departure Alert System (w/ Steering Control)

      Click here

      Stop and Start System
      Variable Gear Ratio Steering System
      Parking Assist Monitor System (w/o Parallel Parking Assist Function)
      Pre-collision System
      Air Conditioning System

  2. Note


    • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


      • A communication malfunction DTC may be stored.

      • The radio receiver assembly may not operate normally.


    • When replacing the telematics transceiver, be sure to replace it with a new one (w/ Manual (SOS) Switch).

    PRECAUTION FOR AUDIO AND VISUAL SYSTEM


    1. If any of the following parts are replaced, refer to Initialization in Repair Instruction.

      Click here


      • Telematics transceiver*


      • *: w/ Manual (SOS) Switch