DYNAMIC REAR STEERING SYSTEM, Diagnostic DTC:U0100/41, U0129/41, U0130/41

DTC Code DTC Name
U0100/41 Lost Communication with ECM/PCM "A"
U0129/41 Lost Communication with Brake System Control Module
U0130/41 Lost Communication with Steering Effort Control Module

DESCRIPTION

The DRS ECU (rear steering control ECU) sends and receives data to and from the ECM, skid control ECU (brake actuator assembly) and VGRS ECU (front steering control ECU) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
U0100/41 Lost Communication with ECM/PCM "A"

All conditions are met for approximately 3 seconds or more:


  • 1 second or more elapses after turning the engine switch on (IG).

  • The power source voltage is 10 to 16 V.

  • The signal from the ECM is lost.

  • ECM

  • CAN communication system

 Comes on Engine switch on (IG) again
U0129/41 Lost Communication with Brake System Control Module

All conditions are met for approximately 3 seconds or more:


  • 2 seconds or more elapse after turning the engine switch on (IG).

  • The power source voltage is 10 to 16 V.

  • The signal from the skid control ECU is lost.

  • Skid control ECU (brake actuator assembly)

  • CAN communication system

 Comes on Engine switch on (IG) again
U0130/41 Lost Communication with Steering Effort Control Module

All conditions are met for approximately 3 seconds or more:


  • 1 second or more elapses after turning the engine switch on (IG).

  • The power source voltage is 10 to 16 V.

  • The signal from the VGRS ECU is lost.

  • VGRS ECU (front steering control ECU)

  • CAN communication system

 Comes on Engine switch on (IG) again

CAUTION / NOTICE / HINT

Note

Since DTC C15C9/76 is stored in the VGRS ECU (front steering control ECU), after performing repairs on the dynamic rear steering system, clear the DTCs for the VGRS system.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Chassis > DRS > Clear DTCs

    2. Check for DTCs.

      Click here


      Chassis > DRS > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here