SIDE STEP DISASSEMBLY

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE NO. 1 SIDE STEP BRACKET LH

    A01EQK1

    1. Remove the 2 bolts and side step bracket.

  2. REMOVE NO. 2 SIDE STEP BRACKET LH

    A01ESJK

    1. Detach the clamp.

    2. Remove the 2 bolts and side step bracket.

  3. REMOVE NO. 3 SIDE STEP BRACKET LH

    A01EONF

    1. Remove the 2 bolts and side step bracket.

  4. REMOVE REAR STEP FLOOR WIRE LH

    A01EQIT

    1. Disconnect the connector.

    2. Detach the 4 clamps and remove the rear step floor wire.

  5. REMOVE STEP LIGHT ASSEMBLY

    A01EPSI

    1. Remove the screw and step light.

  6. REMOVE STEP PLATE LH


    1. Detach the 16 clips and remove the step plate.

      Tech Tips

      Detach the clips from the backside of the step plate.

      A01ERWY

  7. REMOVE STEP PANEL LH


    1. Remove the 3 bolts and step panel.

      A01EOR1

  8. REMOVE NO. 2 STEP PLATE STAY

    A01ENO0E01

    1. Put a 4 mm (0.157 in.) drill bit into a drill.

    2. Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill, as shown in the illustration.

      Tech Tips

      Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    3. Lightly press the drill against the rivet, drill off the flanges of the rivet, and remove the step plate stay.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.

      CAUTION:

      Be careful of the drilled rivet as it may become hot.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.

  9. REMOVE STEP COVER REINFORCEMENT LH

    A01EOZHE01

    1. Put a 4 mm (0.157 in.) drill bit into a drill.

    2. Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill, as shown in the illustration.

      Tech Tips

      Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    3. Lightly press the drill against the 2 rivets, drill off the flanges of the 2 rivets, and remove the step cover reinforcement.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.

      CAUTION:

      Be careful of the drilled rivet as it may become hot.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.

  10. REMOVE REAR SIDE DOOR STEP PLATE COVER LH


    1. Detach the 19 claws and remove the rear side door step plate cover.

      A01EPTE