ROOM TEMPERATURE SENSOR (for Front Side) REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01EO0Q

      Detach the 8 claws.

    2. Disconnect the connector and remove the panel pad.

  4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH


    1. A01ER40

      Remove the clip.

    2. Detach the clip and remove the cover.

  5. REMOVE INSTRUMENT SIDE PANEL LH


    1. A01EN4GE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws and remove the side panel.

  6. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01EQ09

      Detach the 5 claws.

    2. Disconnect the connectors and remove the switch hole base.

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ERF3

      Remove the 2 screws.

    2. Detach the 3 claws.

    3. Remove the under cover and disconnect the connectors.

  8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A01EOMY

      Using a screwdriver, detach the 2 claws and open the hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01EOJD

      Remove the 2 bolts.

    3. A01EQBC

      Detach the 16 claws.

    4. A01EN2R

      Detach the 2 claws and remove the sensor.

    5. A01EQEE

      Detach the 2 claws and disconnect the 2 control cables.

    6. Remove the finish panel and then disconnect the connectors.

  9. REMOVE ROOM TEMPERATURE SENSOR

    A01EO25

    1. Disconnect the connector.

    2. Disconnect the hose and remove the sensor.