REAR NO. 2 SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. Remove the rear No. 2 seat assembly Click here.

  2. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    A01EQA6

    1. Detach the 6 clips and 4 claws, and remove the support plate.

  3. REMOVE REAR STEP COVER

    Tech Tips

    Use the same procedure to remove the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Detach the 2 claws and remove the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Detach the 4 claws and remove the step cover.

  4. REMOVE REAR DOOR SCUFF PLATE

    A01EN6Q

    1. w/o Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

    2. A01ERAD

      w/ Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

  5. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    A01ERFB
    A01ESN6

    Tech Tips

    When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. Detach the 3 claws and remove the cover.

    2. A01EOE1

      Remove the bolt and disconnect the rear seat outer belt floor anchor.

    3. A01EQO3

      for LH Side:


      1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.

    4. A01ES5O

      for RH Side:


      1. Detach the 3 claws and remove the cover.

      2. A01EQD8

        Remove the bolt and disconnect the rear seat outer belt floor anchor RH.

    5. w/ Manual Folding-up Function:


      1. Remove the screw, clip and bolt.

      2. Detach the 19 clips and 2 claws.

        A01EPEA

      3. Disconnect the thermistor connector, power outlet socket connector and rear seat lock control lever cable, and then remove the quarter trim panel.

    6. w/ Automatic Folding-up Function:


      1. Remove the screw and clip.

      2. Detach the 19 clips and 2 claws.

        A01ENWJ

      3. Disconnect the thermistor connector and power outlet socket connector, and then remove the quarter trim panel.

  6. REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY


    1. A01EP9XE01

      Remove the bolt and disconnect the seat belt shoulder anchor.


      1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. A01EPBT

        Remove the bolt and seat belt shoulder anchor.

    2. A01ERT7

      Remove the bolt and rear No. 2 seat outer belt.