SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / (desired system) / Data List.

    5. According to the display on the intelligent tester, read the "Data List".

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P-Seatbelt Buckle SW Front passenger side seat belt buckle signal / ON or OFF

      ON: Front passenger side seat belt is fastened

      OFF: Front passenger side seat belt is unfastened

      		 -
      D - Side Seatbelt Warning Buzzer Driver side seat belt warning signal / ON or OFF

      Current customize setting displayed

      ON: Active

      OFF: Not active

      		 -
      P - Seatbelt Warning Buzzer Front passenger side seat belt warning signal / ON or OFF

      Current customize setting displayed

      ON: Active

      OFF: Not active

      		 -
      SRS Airbag
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver side Buckle SW Driver side seat belt / set or unset

      Set: Driver side seat belt is fastened

      Unset: Driver side seat belt is unfastened

      		 -
      Passenger side Buckle SW Front passenger side seat belt / set or unset

      Set: Front passenger side seat belt is fastened

      Unset: Front passenger side seat belt is unfastened

      		 -

  2. PERFORM ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Combination Meter / Active Test.

    5. According to display on the intelligent tester, perform the "Active Test".

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Indicat. Lamp D-Seat Belt Driver side seat belt warning light ON or OFF Confirm that the Vehicle is Stopped and Engine Idling
      Indicat. Lamp P-Side Seat Belt Front passenger side seat belt warning light ON or OFF Confirm that the Vehicle is Stopped and Engine Idling