SEAT BELT CONTROL ECU (for RHD) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01EO0Q

      Detach the 8 claws.

    2. Disconnect the connector and remove the panel pad.

  4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH


    1. A01ER40

      Remove the clip.

    2. Detach the clip and remove the cover.

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ESEG

      Detach the 4 claws.

    2. Remove the under cover and disconnect the connector.

  6. REMOVE FRONT DOOR SCUFF PLATE LH

    A01EQ14

    1. w/o Illumination:


      1. Detach the 7 claws and 4 clips, and remove the scuff plate.

    2. A01EOWQ

      w/ Illumination:


      1. Detach the 7 claws and 4 clips.

      2. Disconnect the connector and remove the scuff plate.

  7. REMOVE COWL SIDE TRIM BOARD LH


    1. A01EQ1Q

      Remove the cap nut.

    2. Detach the 2 clips and remove the trim board.

  8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. A01ERFH

      Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag.

    3. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  9. REMOVE INSTRUMENT PANEL BOX DOOR KNOB


    1. A01EP2N

      Using a moulding remover, detach the 2 claws and remove the knob.

  10. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. A01EPKU

      Remove the 4 bolts.

    2. Detach the 4 claws.

    3. Remove the finish panel and then disconnect the connector.

  11. REMOVE SEAT BELT CONTROL ECU

    A01ENPZ

    1. Disconnect the 2 connectors.

    2. Remove the nut and ECU.