AIRBAG CUT-OFF SWITCH REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL RH

    A01ENX0E01

    1. w/o Airbag Cut Off Switch:


      1. Place protective tape as shown in the illustration.

      2. Using a moulding remover, detach the 6 claws and remove the side panel.

    2. w/ Airbag Cut Off Switch:


      1. Place protective tape as shown in the illustration.

      2. Using a moulding remover, detach the 6 claws.

      3. Remove the side panel and disconnect the connector.

  4. REMOVE AIRBAG CUT-OFF SWITCH


    1. A01EOKN

      Detach the 2 claws and remove the airbag cut-off switch.