REAR FLOOR AIRBAG SENSOR INSTALLATION


  1. INSTALL REAR FLOOR AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. A01EPPK

      Install the rear floor airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the rear floor airbag sensor.

    5. Connect the connector.

    6. A01EOWS

      Attach the clip and claw to install the cover.

    7. Return the floor carpet to its original position.

  2. INSTALL REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  3. INSTALL REAR DOOR SCUFF PLATE LH

    A01EN6Q

    1. w/o Illumination Type Front Door Scuff Plate:


      1. Attach the 3 claws and 4 clips to install the scuff plate.

      2. Install the screw.

    2. A01ERAD

      w/ Illumination Type Front Door Scuff Plate:


      1. Attach the 3 claws and 4 clips to install the scuff plate.

      2. Install the screw.

  4. INSTALL REAR STEP COVER

    Tech Tips

    Use the same procedure to install the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Attach the 2 claws to install the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Attach the 4 claws to install the step cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.