REAR FLOOR AIRBAG SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR STEP COVER

    Tech Tips

    Use the same procedure to remove the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Detach the 2 claws and remove the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Detach the 4 claws and remove the step cover.

  4. REMOVE REAR DOOR SCUFF PLATE LH

    A01EN6Q

    1. w/o Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

    2. A01ERAD

      w/ Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

  5. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  6. REMOVE REAR FLOOR AIRBAG SENSOR


    1. Fold back the floor carpet.

    2. A01EOWS

      Detach the clip and claw, and remove the cover.

    3. A01EPPK

      Remove the bolt and sensor.

    4. Disconnect the connector.