SIDE AIRBAG SENSOR INSTALLATION


  1. INSTALL SIDE AIRBAG SENSOR


    1. A01EN45

      Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the side airbag sensor.

    5. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Connect the connector.

    2. A01EO3L

      Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.

    3. A01EMZN

      Attach the 4 claws and 14 clips to install the front door trim board sub-assembly LH.

    4. Install the 2 screws.

  3. INSTALL FRONT ARMREST UPPER BASE PANEL LH


    1. Connect the connector.

    2. Attach the 5 claws to install the front upper armrest base panel LH.

  4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH


    1. Attach the 3 claws to install the front door inside handle bezel plug LH.

  5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. Attach the clip and claw to install the front lower door frame bracket garnish LH.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.