KNEE AIRBAG ASSEMBLY (for Front Passenger Side) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  4. REMOVE COWL SIDE TRIM BOARD RH


    1. A01ENCL

      Remove the cap nut.

    2. Detach the 2 clips and remove the trim board.

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ESEG

      Detach the 4 claws.

    2. Remove the under cover and disconnect the connector.

  6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A01EP7O

      Detach the 9 claws and remove the panel pad.

  7. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH


    1. A01EO0O

      Detach the clip and remove the cover.

  8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. A01ERFH

      Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag.

    3. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.