STEERING PAD INSTALLATION


  1. INSTALL STEERING PAD


    1. A01EQYD

      Support the steering pad with one hand.

    2. Connect the 2 connectors to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A01EOLU

      Attach the 2 claws to install the cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A01ES8Q

      Attach the 2 claws to install the cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  6. INSPECT STEERING PAD


    1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

      Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.