STEERING PAD REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A01EOLU

      Detach the 2 claws and remove the steering wheel cover.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A01ES8Q

      Detach the 2 claws and remove the steering wheel cover.

  5. REMOVE STEERING PAD


    1. A01ER4PE01

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A01EQYD

      Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the 2 connectors and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.