METER / GAUGE SYSTEM OPERATION CHECK


  1. INSPECT INDICATOR/WARNING LIGHT


    1. Check the following indicators and warning lights.

      Indicator/Warning Light Switch Condition Specified Condition
      ABS warning light Engine switch off → on (IG) Comes on for 3 seconds
      SLIP indicator light
      VSC OFF indicator light
      RSCA OFF indicator light
      ACCESS MODE indicator light
      CRAWL indicator light
      PCS indicator light*1
      AFS OFF indicator light
      BRAKE warning light
      SPEED LIMIT indicator light*2
      Eco driving indicator light
      Turn assist indicator light
      Multi-terrain select indicator light
      Tire pressure warning light*3
      SRS warning light Engine switch off → on (IG) Comes on for 6 seconds
      CHARGE warning light Engine switch off → on (IG) Illuminates when engine switch is turned on (IG). Turns off when engine is started.
      MIL

      *1: w/ Pre-Crash Safety System

      *2: for Middle East

      *3: w/ Tire Pressure Warning System

  2. INSPECT SPEEDOMETER


    1. Using a speedometer tester, check that the speedometer reading is within the allowable range shown in the table below. Also, check for proper operation of the odometer.

      If the result is not as specified, the speedometer may have a malfunction.

      *1: for Australia

      Note

      Do not use worn, underinflated or overinflated tires, as the speedometer reading will be inaccurate.

    2. Check the deflection width of the speedometer indicator.

    3. INSPECT TACHOMETER


      1. Connect a tune-up tachometer and start the engine.

      2. Compare the test results with the tachometer indicator.

      4. If the result is not as specified, the tachometer may have a malfunction.

    4. INSPECT METER/GAUGE


      1. Connect the intelligent tester to the DLC3.

      2. Perform Active Test Click here.

    5. INSPECT WARNING/INDICATOR LIGHT


      1. Connect the intelligent tester to the DLC3.

      2. Perform Active Test Click here.

    6. INSPECT ENGINE OIL LEVEL WARNING


      1. Turn the engine switch on (IG) and warm up the engine at an engine speed of 2000 rpm or less until the coolant temperature reaches approximately 80°C (176°F) or more.

      2. Disconnect the engine oil level sensor connector for 40 seconds or more.

      3. Turn the engine switch on (IG) and check the multi-information display.

    7. INSPECT MULTI-INFORMATION DISPLAY


      1. Connect the intelligent tester to the DLC3.

      2. Perform Active Test Click here.

        Tech Tips

        If this Active Test is being performed and the engine switch is turned off and then on (IG), the A/T and ODO/TRIP display background may turn white. If this occurs, end the Active Test and turn the engine switch off.