ENGINE HOOD COURTESY SWITCH INSTALLATION

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. INSTALL HOOD LOCK ASSEMBLY


    1. A01EO5ME03

      Apply MP grease to the sliding areas of the lock.

    2. A01ESIN

      Connect the hood lock control cable.

    3. A01ENW2

      Connect the connector.

    4. Install the hood lock with the 2 bolts and nut.

      Torque:
      5.5 N*m  { 57 kgf*cm, 49 in.*lbf }

    5. Install a new hood lock nut cap.

  2. INSTALL HOOD LOCK CONTROL CABLE COVER

    A01EQ1D

    1. Attach the claw to install the cover.

    2. Install the 3 screws.

  3. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    1. Temporarily install the millimeter wave radar sensor assembly with the 3 bolts.

    2. A01EOHGE01

      Tighten the 3 bolts in alphabetical order.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the sensor connector.

      Note

      Do not use a sensor which has been dropped or subjected to any strong shocks.

  4. INSTALL RADIATOR GRILLE ASSEMBLY


    1. w/ Wide View Front Monitor System:

      Connect the connector.

    2. Attach the 14 claws to install the radiator grille assembly.

    3. Attach the 4 clips to install the detached part of the upper radiator seal.

    4. Install the screw and 2 clips.

  5. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the upper radiator support seal with the 3 clips.

  6. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  7. INSTALL ENGINE ROOM SIDE COVER RH


    1. Install the engine room side cover RH with the 7 clips.

  8. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    1. Adjust millimeter wave radar sensor Click here.