ENGINE HOOD COURTESY SWITCH REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. REMOVE RADIATOR GRILLE ASSEMBLY


    1. A01EQD7E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the radiator grille assembly.

    2. Remove the screw and 2 clips.

    3. Detach the 4 clips and partially remove the upper radiator seal.

    4. Detach the 14 claws and remove the radiator grille assembly.

    5. w/ Wide View Front Monitor System:

      Disconnect the connector.

  5. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    1. A01EOHG

      Disconnect the sensor connector.

    2. Remove the 3 bolts and sensor.

  6. REMOVE HOOD LOCK CONTROL CABLE COVER

    A01EQ1D

    1. Remove the 3 screws.

    2. Detach the claw and remove the cover.

  7. REMOVE HOOD LOCK ASSEMBLY


    1. A01ENW2

      Remove the hood lock nut cap.

    2. Remove the 2 bolts and nut.

    3. Disconnect the connector.

    4. A01ESIN

      Disconnect the hood lock control cable and remove the hood lock.