ELECTRICAL KEY OSCILLATOR (for Rear Floor) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

  3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH


    1. Remove the rear No. 1 seat assembly LH Click here.

  4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    1. Remove the rear No. 1 seat assembly RH Click here.

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. Remove the rear No. 2 seat assembly Click here.

  6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. Remove the front quarter trim panel assembly LH Click here.

  7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH


    1. Remove the front quarter trim panel assembly RH Click here.

  8. REMOVE REAR NO. 1 SEAT PROTECTOR

    A01EOBFE01

    1. Detach the 10 claws and remove the 2 seat protectors.

  9. REMOVE REAR NO. 2 SEAT PROTECTOR

    A01EMYNE01

    1. Detach the 10 claws and remove the 2 seat protectors.

  10. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR


    1. Fold back the front floor carpet assembly.

    2. A01EQ8H

      Disconnect the connector.

    3. Detach the 2 claws and remove the electrical key oscillator.