ENTRY LOCK AND UNLOCK SWITCH (for Rear) REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01ENEKE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 3 claws and remove the rear door inside handle bezel plug LH.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    1. A01EO3E

      Using a moulding remover, detach the 6 claws.

    2. Disconnect the connector and remove the rear upper door armrest base panel LH and rear power window regulator switch assembly.

  5. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01EOJ3

      Detach the claw.

    2. Remove the courtesy light and then disconnect the connector.

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01ERTKE01

      Remove the 2 screws.

    2. Detach the 11 clips.

    3. Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

      Tech Tips

      Make sure that the pin labeled A in the illustration is detached from the door panel.

    4. Disconnect the connector.

    5. A01EPPA

      Disconnect the 2 cables from the rear door inside handle sub-assembly LH.

  7. REMOVE REAR DOOR TRIM COVER LH


    1. A01EOI1

      Detach the 7 clips and remove the rear door trim cover LH.

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH


    1. A01ERCQ

      Using a clip remover, detach the 6 clamps.

    2. Remove the bolt and disconnect the 2 connectors.

    3. Remove the rear door service hole cover LH.

      Tech Tips

      Remove the remaining tape on the door.

  9. REMOVE REAR DOOR LOCK ASSEMBLY LH


    1. A01ENYX

      Using a T30 "TORX" socket, remove the 3 screws and door lock.

      Note

      Be careful when removing the screws as the door lock may fall and become damaged.

  10. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH


    1. A01ES76

      Using a T30 "TORX" socket, loosen the screw.

    2. A01EOIW

      Detach the claw and remove the rear door outside handle cover LH.

  11. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. A01EPBO

      Using a T30 "TORX" wrench, loosen the screw.

    2. Disconnect the connector.

    3. A01ENJZ

      Remove the handle by sliding and pulling it in the direction indicated by the arrows in the illustration.