ENTRY AND START SYSTEM (for Start Function), Diagnostic DTC:B2289

DTC Code DTC Name
B2289 Key Collation Waiting Time Over

DESCRIPTION

This DTC is stored when there is a LIN communication problem between the main body ECU and certification ECU (smart key ECU assembly) or when there is a problem in the engine immobiliser system.

DTC Code Detection Condition Trouble Area
B2289

When either of the following conditions is met:


  • Communication or the communication line among the main body ECU, certification ECU (smart key ECU assembly), steering lock ECU and ID code box (immobiliser code ECU) is abnormal.

  • The immobiliser system malfunctions.

  • Main body ECU

  • Engine switch

  • Certification ECU (Smart key ECU assembly)

  • Key

  • Engine immobiliser system

  • Harness or connector

WIRING DIAGRAM

A01ERK7E01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK WHETHER DTC OUTPUT RECURS


    1. Clear the DTCs Click here.

    2. Check whether DTC B2289 is output.

      Result
      Result Proceed to
      DTC B2289 output A
      No DTC output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY])

    A01ESKFE01

    1. Disconnect the 2D main body ECU connector.

    2. Disconnect the E29 certification ECU (smart key ECU assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2D-20 (LIN1) - E29-10 (LIN) Always Below 1 Ω
      2D-20 (LIN1) or E29-10 (LIN) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)


    1. Temporarily replace the main body ECU with a new or normally functioning one.

    2. Check whether DTC B2289 is output.

      OK
      No DTC is output.

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

    OK

    END