BACK DOOR LOCK REMOVAL

REMOVE ENGINE ROOM SIDE COVER LH
1. Remove the 7 clips and engine room side cover LH.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
- w/ Navigation System:
  
  After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE CENTER BACK DOOR GARNISH
1. Detach the 5 clips and 2 claws, and remove the back door garnish.
REMOVE BACK DOOR SIDE GARNISH LH
1. Detach the 3 clips and remove the back door side garnish.
REMOVE BACK DOOR SIDE GARNISH RH
1. w/o Power Back Door:
  
  Tech Tips
  
  Use the same procedures described for the LH side.
2. w/ Power Back Door:
  1. Detach the clip and 2 claws and remove the back door side garnish.
REMOVE BACK DOOR GARNISH
1. Using a screwdriver, detach the 14 clips and remove the back door garnish.
REMOVE BACK DOOR LOCK COVER
1. Detach the 4 claws and remove the cover.
REMOVE BACK DOOR LOCK ASSEMBLY
1. w/o Power Back Door:
  1. Disconnect the connector.
  2. Remove the 3 bolts and door lock.
2. w/ Power Back Door:
  1. Disconnect the connector.
  2. Detach the guide.
  3. Remove the 4 bolts and door lock assembly.
REMOVE BACK DOOR LOCK PROTECTOR (w/ Power Back Door)
1. Remove the screw.
2. Text in Illustration
  
  *1 Protector (B)
  
  Detach the 7 claws and remove the protector (B).
3. Text in Illustration
  
  *1 Protector (A)
  
  Detach the 2 claws and remove the protector (A).