REAR DOOR LOCK INSPECTION


  1. INSPECT REAR DOOR LOCK ASSEMBLY LH

    A01EOXFE06

    1. Check the door lock motor operation.


      1. Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 4 (L)

        Battery negative (-) → 1 (UL)

        		 Lock

        Battery positive (+) → 1 (UL)

        Battery negative (-) → 4 (L)

        		 Unlock

        • If the result is not as specified, replace the door lock assembly.

    2. Check the detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        6 (LSSR) - 9 (E) Unlock Below 1 Ω
        6 (LSSR) - 9 (E) Lock 10 kΩ or higher

        • If the result is not as specified, replace the door lock assembly.

  2. INSPECT REAR DOOR LOCK ASSEMBLY RH

    A01ER0NE05

    1. Check the door lock motor operation.


      1. Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 4 (L)

        Battery negative (-) → 1 (UL)

        		 Lock

        Battery positive (+) → 1 (UL)

        Battery negative (-) → 4 (L)

        		 Unlock

        • If the result is not as specified, replace the door lock assembly.

    2. Check the detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        6 (LSSR) - 9 (E) Unlock Below 1 Ω
        6 (LSSR) - 9 (E) Lock 10 kΩ or higher

        • If the result is not as specified, replace the door lock assembly.