FRONT DOOR LOCK INSPECTION


  1. INSPECT FRONT DOOR LOCK ASSEMBLY LH

    A01ESJPE06

    1. Check the door lock motor operation.


      1. Apply battery voltage to the motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 4 (L)

        Battery negative (-) → 1 (UL)

        		 Lock

        Battery positive (+) → 1 (UL)

        Battery negative (-) → 4 (L)

        		 Unlock

        • If the result is not as specified, replace the door lock assembly.

    2. Check the detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        8 (LSSR) - 7 (E) Lock 10 kΩ or higher
        8 (LSSR) - 7 (E) Unlock Below 1 Ω

        • If the result is not as specified, replace the door lock assembly.

    3. for LHD:

      A01EOA3E07

      1. Check the door lock and unlock switch.


        1. Measure the resistance according to the value(s) in the table below.

          Standard Resistance
          Tester Connection Switch Condition Specified Condition
          9 (L) - 7 (E) Lock Below 1 Ω

          9 (L) - 7 (E)

          10 (UL) - 7 (E)

          		 Off 10 kΩ or higher
          10 (UL) - 7 (E) Unlock Below 1 Ω

        • If the result is not as specified, replace the door lock assembly.

  2. INSPECT FRONT DOOR LOCK ASSEMBLY RH

    A01EQVKE06

    1. Check the door lock motor operation.


      1. Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 4 (L)

        Battery negative (-) → 1 (UL)

        		 Lock

        Battery positive (+) → 1 (UL)

        Battery negative (-) → 4 (L)

        		 Unlock

        • If the result is not as specified, replace the door lock assembly.

    2. Check the detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        7 (LSSR) - 8 (E) Lock 10 kΩ or higher
        7 (LSSR) - 8 (E) Unlock Below 1 Ω

        • If the result is not as specified, replace the door lock assembly.

    3. for RHD:

      A01EP41E02

      1. Check the door lock and unlock switch.


        1. Measure the resistance according to the value(s) in the table below.

          Standard Resistance
          Tester Connection Switch Condition Specified Condition
          9 (L) - 7 (E) Lock Below 1 Ω

          9 (L) - 7 (E)

          10 (UL) - 7 (E)

          		 OFF 10 kΩ or higher
          10 (UL) - 7 (E) Unlock Below 1 Ω

        • If the result is not as specified, replace the door lock assembly.