NETWORK GATEWAY ECU (for LHD) INSTALLATION


  1. INSTALL NETWORK GATEWAY ECU

    A01EPNK

    1. Install the ECU with the nut.

    2. Connect the connector.

  2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. A01EPKU

      Connect the connector.

    2. Attach the 4 claws to install the finish panel.

    3. Install the 4 bolts.

  3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB


    1. A01EPJO

      Attach the 2 claws to install the knob.

  4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. A01ERSS

      Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Attach the 4 claws to install the front passenger side knee airbag.

    3. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  5. INSTALL COWL SIDE TRIM BOARD RH


    1. A01ENCL

      Attach the 2 clips to install the trim board.

    2. Install the cap nut.

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ESFI

      Connect the connector.

    2. Attach the 4 claws to install the under cover.

  8. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH


    1. A01EO0O

      Attach the clip to install the cover.

  9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A01EP7O

      Attach the 9 claws to install the panel pad.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  12. CHECK SRS WARNING LIGHT

    Click here