REAR BUMPER (w/ Pintle Hook) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR


    1. Install the No. 2 luggage compartment side cover protector with 2 new grommets.

    2. Install the 2 screws.

  2. INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

    Tech Tips

    Use the same procedure described for the No. 2 luggage compartment side cover protector.

  3. INSTALL REAR BUMPER ARM BRACKET LH


    1. Install the rear bumper arm bracket LH with the 2 bolts.

    2. Connect the connector.

  4. INSTALL REAR BUMPER ARM BRACKET


    1. Install the rear bumper arm bracket with the bolt.

      Tech Tips

      Use the same procedure to install the rear bumper arm bracket on the other side.

  5. INSTALL REAR NO. 2 BUMPER REINFORCEMENT


    1. Install the rear No. 2 bumper reinforcement with the 2 bolts.

  6. INSTALL REAR BUMPER SIDE SUPPORT LH


    1. Attach the 6 claws to install the rear bumper side support LH.

    2. Install the 3 screws.

  7. INSTALL REAR BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL REAR UPPER BUMPER RETAINER LH


    1. Attach the 2 clips to install the rear upper bumper retainer LH.

  9. INSTALL REAR UPPER BUMPER RETAINER RH

    Tech Tips

    Use the same procedure described for the LH side.

  10. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH


    1. Connect the connector.

    2. Attach the 2 clips and install the rear combination light assembly LH.

    3. Install the 2 bolts.

    4. Attach the 6 claws and install the 2 covers.

  11. INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  12. INSTALL REAR BUMPER COVER


    1. Connect the No. 2 frame wire connector and attach the 14 claws to install the rear bumper cover.

    2. Install the 7 bolts, 6 screws and 2 clips.

    3. Open the tail gate and install the 4 clips.

    4. Close the tail gate.

  13. INSTALL REAR NO. 1 BUMPER PLATE


    1. Attach the 20 claws to install the rear No. 1 bumper plate.

  14. INSTALL REAR QUARTER PANEL MUDGUARD LH

    A01ESAQ

    1. Install the mudguard with the clip.

    2. Using a T30 "TORX" socket, install the 7 screws.

  15. INSTALL REAR QUARTER PANEL MUDGUARD RH

    A01ENPF

    1. Install the mudguard with the clip.

    2. Using a T30 "TORX" socket, install the 8 screws.

  16. INSTALL PINTLE HOOK ASSEMBLY


    1. Install the pintle hook assembly and pintle hook bracket with the 2 bolts, 2 eyelet pintle hooks and 4 nuts.

      Torque:
      for nut
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

    2. For vehicles with a spare installed to the underbody, install the spare tire.