PARKING ASSIST MONITOR SYSTEM (w/ Side Monitor System), Diagnostic DTC:C1612

DTC Code DTC Name
C1612 IG Voltage is Low or High

DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal IG is low or high.

DTC Code DTC Detection Condition Trouble Area
C1612

  • IG voltage is low

  • IG voltage is high

  • Harness or connector

  • Parking assist ECU

WIRING DIAGRAM

A01EQOKE62

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1612 is not output.

      Tech Tips

      If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.


    NG

    CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)


    1. A01EMY0E03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Parking Assist ECU)

      Disconnect the parking assist ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F74-4 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      F74-8 (IG) - F74-4 (GND1) Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE PARKING ASSIST ECU Click here