DESCRIPTION
If the telematics transceiver receives a result "Defect", "High Temperature" or "Low Voltage" or cannot receive any signals when mayday battery self-diagnosises.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15CC | Mayday battery malfunction |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Tech Tips
When replacing the telematics transceiver, perform the vehicle contract setting Click here.
PROCEDURE
CHECK DTC
Clear the DTC Click here.
Recheck for DTCs and check if the same trouble occurs again.
| OK |
|---|
| No DTC is output. |
| NG |
|
CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY BATTERY) Click here |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here
CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY BATTERY)
Disconnect the P2 telematics transceiver connector.
Disconnect the j1 mayday battery connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK MAYDAY BATTERY
Replace the mayday battery with a normal one and check if the same problem occurs again Click here.
Clear the DTC Click here.
Recheck for DTCs and check if the same trouble occurs again.
| OK |
|---|
| No DTC is output. |
| NG |
|
REPLACE TELEMATICS TRANSCEIVER Click here |
| OK |
|
END (MAYDAY BATTERY IS DEFECTIVE)