Tech Tips
A bolt without a torque specification is shown in the standard bolt chart Click here.
INSTALL NO. 2 MULTI-DISPLAY CONTROLLER BRACKET
Set the aligning protrusions of the No. 2 multi-display controller bracket, labeled A, into the multi-display controller sub-assembly holes.
Install the No. 2 multi-display controller bracket with the 2 bolts labeled B.
INSTALL NO. 3 MULTI-DISPLAY CONTROLLER BRACKET
Set the aligning protrusions of the No. 3 multi-display controller bracket, labeled A, into the multi-display controller sub-assembly holes.
Install the No. 3 multi-display controller bracket bracket with the 2 bolts labeled B.
INSTALL MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY WITH BRACKET
Install the multi-display controller sub-assembly with bracket with the 3 bolts.
Connect the connectors.
INSTALL FRONT FLOOR CARPET ASSEMBLY
Install the carpet that was pulled back to remove the selector. For further details, refer to the installation procedure Click here.
INSTALL FRONT DOOR SCUFF PLATE RH
Tech Tips
Use the same procedures described for the LH side.
INSTALL COWL SIDE TRIM BOARD RH
Attach the 2 clips to install the trim board.
Install the cap nut.
INSTALL INSTRUMENT SIDE PANEL RH
w/o Airbag Cut Off Switch:
Attach the 6 claws to install the side panel.
w/ Airbag Cut Off Switch:
Connect the connector.
Attach the 6 claws to install the side panel.
INSTALL FRONT SEAT ASSEMBLY RH
Install the front seat assembly RH Click here.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL ENGINE ROOM SIDE COVER LH
Install the engine room side cover LH with the 7 clips.
CHECK SRS WARNING LIGHT
Check the SRS warning light Click here.