RADIO ANTENNA CORD INSTALLATION


  1. INSTALL ANTENNA CORD SUB-ASSEMBLY


    1. Attach the 7 clamps to install the antenna cord.

      A01EPYL

  2. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY


    1. Install the instrument panel safety pad Click here.

  3. INSTALL ANTENNA CORD SUB-ASSEMBLY


    1. Apply new double-sided tape as shown in the illustration.

      Tech Tips

      Attach double-sided tape to the hatched areas shown in the illustration below.

      A01ESE0E01

    2. Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.

    3. Attach the 2 clamps and fit the antenna into the 3 ribs and the notch.

  4. INSTALL ROOF HEADLINING ASSEMBLY


    1. Install the roof headlining Click here.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.