LUGGAGE SPEAKER INSTALLATION

INSTALL NO. 1 WOOFER BOX SPEAKER ASSEMBLY
1. Install the box speaker with the 5 bolts.
2. Connect the connector.
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH
Tech Tips

When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.
1. Connect the thermistor connector.
2. Attach the 17 clips and 2 claws to install the quarter trim panel.
3. Install the clip.
4. Install the rear No. 2 seat belt anchor with the bolt.
  
  Torque:
  
  42 N*m { 428 kgf*cm, 31 ft.*lbf }
5. Attach the 3 claws to install the cover.
6. Install the rear No. 1 seat belt anchor with the bolt.
  
  Torque:
  
  42 N*m { 428 kgf*cm, 31 ft.*lbf }
7. Attach the 3 claws to install the cover.
INSTALL REAR DOOR SCUFF PLATE RH

Tech Tips

Use the same procedures described for the LH side.
INSTALL REAR STEP COVER
Tech Tips

Use the same procedure to install the step cover on the other side.
1. w/o Illumination Type Front Door Scuff Plate:
  
  Attach the 2 claws to install the step cover.
2. w/ Illumination Type Front Door Scuff Plate:
  
  Attach the 4 claws to install the step cover.
INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
1. Attach the 6 clips and 4 claws to install the support plate.
INSTALL REAR NO. 2 SEAT ASSEMBLY

Install the rear No. 2 seat assembly Click here.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL REAR NO. 2 SEAT HINGE COVER RH
1. Attach the 3 claws and 2 clips to install the cover.
INSTALL REAR SEAT CUSHION HINGE COVER RH
1. Attach the 3 claws to install the cover.
2. Return the seat to the upright position.
INSTALL ENGINE ROOM SIDE COVER LH
1. Install the engine room side cover LH with the 7 clips.