LUGGAGE SPEAKER REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE REAR SEAT CUSHION HINGE COVER RH

    A01EMW4

    1. Apply protective tape to the rear seatback lock striker as shown in the illustration to prevent the seat from locking.

    2. Operate the power seat switch and move the seat to the storage position.

      Tech Tips

      Make sure that the lock and striker are not engaged.

    3. A01EN36

      Using a screwdriver, detach the 3 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE REAR NO. 2 SEAT HINGE COVER RH

    A01EN8L

    1. Detach the 3 claws and 2 clips, and then remove the cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY

    Remove rear no. 2 seat assembly Click here.

  6. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    A01EQA6

    1. Detach the 6 clips and 4 claws, and remove the support plate.

  7. REMOVE REAR STEP COVER

    Tech Tips

    Use the same procedure to remove the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Detach the 2 claws and remove the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Detach the 4 claws and remove the step cover.

  8. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    A01ENK2

    Tech Tips

    When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. A01EOL1

      Detach the 3 claws and remove the cover.

    2. A01EPT5

      Remove the bolt and rear No. 1 seat belt anchor.

    3. A01ES5O

      Detach the 3 claws and remove the cover.

    4. A01EQD8

      Remove the bolt and rear No. 2 seat belt anchor.

    5. Remove the clip.

    6. Detach the 17 clips and 2 claws.

    7. Disconnect the thermistor connector and then remove the quarter trim panel.

      A01EREO

  10. REMOVE NO. 1 WOOFER BOX SPEAKER ASSEMBLY


    1. Disconnect the connector.

    2. A01ENTM

      Remove the 5 bolts and box speaker.